Konica Minolta bizhub PRESS C8000e - Manual (Page 362)

bizhub PRESS C8000 10-54
10.9 [03 Administrator Setting] - [01 System Setting] 10
1
Follow the procedure on page 10-2 to display the Administrator Setting Menu Screen.
2
Press [01 System Setting], [05 Expert Adjustment], [07 Quality Adjustment], and [02 Printer Gamma Off-
set Auto.] in sequence.
The Printer Gamma Offset Automatic Adjustment Screen will be displayed.
3
Use [Next] and [Previous] to select the screen to be adjusted.
% Contone is the screen used in texts when Line 1, Line 2, Dot 1, or Dot 2 is used, and consequently
does not require this adjustment.
4
Press [Readjust].
% If the gradation appears widely misaligned in highlights of the image, press [Reset Adj. Data] to set
the printer gamma offset adjustment value to "0", then press [Readjust].
A dialog will be displayed for confirmation of readjustment.
5
Press [Yes].
Or, press [No] to cancel the readjustment.
6
Press [Print Mode].
The Print Mode Screen will be displayed.
7
Select A4
v paper tray, then press Start on the control panel.
A test pattern will be output, and the Printer Gamma Offset Automatic Adjustment Screen will be re-
stored automatically.
8
Place the test pattern on the original glass.
% Position the test pattern [1] face down, with green arrow [2] pointing at the left side.
% Carefully align the test pattern [1] to the vertical original size guide [3] and horizontal original size
guide [4] on the original glass.
% Place about 10 sheets of blank copy paper on top of the test pattern [1].
% Close the ADF.