Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 72)

AlliedView™-EMS 4.0.2 Device Management Guide Page 72 of 441
SNTP/NTP Client Config
Displays information about SNTP/NTP client configuration.
Note - Valid MIB Set values for the Polling Interval parameter should range from 60
to 86400. However, the current firmware version allows the user to enter values in
the range [-2147483648 to 2147483647] inclusive. Attempting to enter values
greater than 2147483647 will cause the new value to be converted to its equivalent
wrap-around value; i.e., 2147483648 will become -2147483648, 2147483649 will
become -2147483647, and so on.
SNTP Config
Displays information about SNTP client configuration.
Broadcast Mode
Displays information about broadcast mode per interface.
Note - The current firmware version returns a 'noSuchName' value for the IP
Address parameter.
SNTP Server Info
Displays information about trusted SNTP servers to be queried in unicast or
broadcast mode.
Authentication Keys
Displays information about keys information for authentication of NTP packets.
System Log
Basic Info
Displays information and configuration of the device's log files.
Note - Setting the Clear Log File and Clear Cache parameters to a value other than 0
will delete the log file and clear the cache memory but the value used will not be
retained.
Event Log
Displays information about events sent to the system log file.
Error Log
Displays information about errors registered to the system cache.
Syslog Device
Displays information about Syslog diagnostic messages.
Note - Device Manager does not handle 8-bit string parameters correctly. As a
result, the Syslog Device Control parameter will display the string "00000000" and
will not be configurable.