Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 59)

AlliedView™-EMS 4.0.2 Device Management Guide Page 59 of 441
Detail Info
Displays detailed port information such as duplex mode.
Note - The current firmware version does not allow the following parameters to be
configured:
o
Tagged Mode
o
Default Priority
o
Row Status
o
Port Flow Control Config
o
Port Speed
o
Reactive and Combo Ethernet Config
Attempting to configure these parameters to any valid value will result in the error
"The error occurred with 'Set' operation. Error. bad value." except for the Default
Priority parameter.
Note - The current firmware version does not allow the Host Mode parameter to be
set to 'multiple-auth' as its value.
Note - The current firmware version does not allow the Autonegotiation Capabilities
Config parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation. Error.
bad value.".
Note - The Physical Address Type parameter is not applicable to the AT-8000GS
series and should be ignored.
Note - The current firmware version does not allow the Port Duplex Config
parameter to be set to 'half' as its value.
Note - The combo ports will not display the Port Context Menu on right-mouse
click if logged-on in an SNMPv3 mode using a user account with no read-write
access to the Transceiver Type parameter.
POE Port Status
Displays additional information for Power Over Ethernet ports.
Note - Valid MIB Set values for the Port Power Limit parameter is [0 - 2147483647].
However, the current firmware version does not allow this parameter to be
configured to any value. Attempting to configure this parameter from 15401-
2147483647 will result in the error "The error occurred with 'Set' operation. Error:
gen error".
Spanning Tree Info
STP
Detail Info
Displays the port's spanning tree parameters.