Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 35)

AlliedView™-EMS 4.0.2 Device Management Guide Page 35 of 441
Note - Valid MIB Set values for the Physical Alias parameter should range from 0 to
32. However, the current firmware version allows the user to enter up to 6
characters only.
Note - Valid MIB Set values for the Physical Asset ID parameter should range from 0
to 32. However, the current firmware version allows the user to enter up to 16
characters only.
Note - The current firmware version does not return any value for the Serial
Number parameter.
Stacking Info
Basic Info
Displays the stacking information.
Note - Stacked devices: The current firmware version does not allow the Stack
Reload Unit parameter to be set to a non-existing Unit ID. Attempting to do so will
result to an error.
Note - The current firmware version does not allow the Stack Order Permutation
parameter to be configured.
Note - Valid MIB Set values for the Force Master Unit, Top Unit and Bottom Unit
parameters are [1-2], [1-6] and [1-6] respectively. However, the current firmware
version allows the user to set these parameters to '0'.
Stack Info
Displays information about the stacked devices.
Stack Status
Displays the current unit ID and stack mode of the device after reset.
Note - Valid MIB Set values for the Active Unit ID After Reset parameter is [1-6]
inclusive. However, the current firmware version allows the user to set this
parameter to '0'.
Stack Unit Mode
Displays the device's current stacking mode.
Cascaded Ports Info
Displays cascaded ports information for stacked devices.
Cascaded Port Config
Displays cascaded port information in a unit after reset.
Note - Configuring the Row Status parameter to invalid values will not return an
error message except for the 'create and go' value.