Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 61)

AlliedView™-EMS 4.0.2 Device Management Guide Page 61 of 441
Note - The current firmware version does not allow the PAUSE Config parameter to
be set to 'enabledXmit' or 'enabledRcv' as its value.
Port Trunking
Basic Info
Displays basic information about port trunking.
Note - The current firmware version does not allow the Trunk Creation Support
and LACP Membership Restrictions Support parameters to be configured.
Balancing Criteria
Displays information about Aggregate Index.
Note - The current firmware version does not allow the Used Addresses and
Broadcast Type parameters to be configured.
Aggregator Info
Displays information about every Aggregator that is associated with this system.
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Aggregation Port Info
Displays a list of Link Aggregation Control configuration parameters for each
Aggregation Port on this device.
Note - The current firmware version does not allow the Actor Administrative Key
and Partner Administrative System ID parameters to be configured. Attempting to
configure these parameters to any valid value will result in the error "The error
occurred with 'Set' operation. Error. bad value.".
Note - Device Manager does not handle 8-bit string parameters correctly. As a
result, the Actor Administrative Status and Partner Administrative Status parameters
will display unrecognizable values and will not be configurable.
Storm Control
Basic Info
Displays basic information about storm control.
Storm Control Protection
Displays information about the storm control protection per port.
Note - The current firmware version does not allow any of the parameters under
this table to be configured except for the Broadcast Enable and Multicast Enable
parameters.