Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 152)

AlliedView™-EMS 4.0.2 Device Management Guide Page 152 of 441
LAN/WAN Menu
From the LAN/WAN menu, you can view and edit information for the LAN/WAN such as
the frame relay and ISDN-related information. The submenus are unavailable if the proper
PICs are not installed.
Bridging
Forwarding Database
Displays the Forwarding Database table as returned by the device.
Discard/Aging Time Info
Displays information about the number of address entries that were learned but
discarded for reasons such as lack of memory or the entry's aging timer.
Spanning Tree Info
Displays spanning tree parameters such as priority and cost.
Statistics
Displays statistics about frames received/transmitted on the switch port.
Basic Bridge Info
Displays basic bridge information.
Bridge Port Info
Displays bridge port information.
Note - The current firmware version returns the value 'NULL' for the Circuit
parameter.
ISDN
Call Details
Displays ISDN call information such as ISDN number and call direction for active
calls.
Note - The Remote Call parameter does not allow input values that contain hyphens.
Note - If the In CLI (Calling Line Info) Search parameter is set to 'list', the In CLI
(Calling Line Info) List Check parameter gives the index of the CLI list to search.
The value of CLI list indices ranges from 1 to 100. The value 0 is returned if the In
CLI (Calling Line Info) Search parameter is not set to 'list'. When the In CLI (Calling
Line Info) List Check parameter is set to 0, the In CLI (Calling Line Info) Search
parameter is internally set to 'off'. Subsequently setting it to a non-zero value will set
the In CLI (Calling Line Info) Search parameter to 'list'. Note that when using the
command line interface, CLI List indices range from 0 to 99, but when using Device
Manager, they range from 1 to 100. This is because SNMP will not allow a table
index to have the value 0, and the command line usage of indices from 0 to 99 is too
well established to change.