Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 279)

AlliedView™-EMS 4.0.2 Device Management Guide Page 279 of 441
Interface Info
Displays the current DNS relay static.
MD5 Key Config
Displays the current MD5 key table.
Note - To configure the MD5 Key parameter, the Row Status parameter must first
be set to 'create and go'. Once the MD5 Key parameter has been configured, the
Row Status parameter is automatically set to 'active'.
Note - If the MD5 Key parameter is set to a new value whose length is shorter than
the length of the previously active MD5 Key, an extra character, as well as the
remaining characters of the previous key, is appended to the new value.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database, discard/aging time information, spanning tree status and 802.1p.
Forwarding Database
Note - A user account assigned a MIB view that excludes a row or multiple rows
from the Forwarding Database table will not be allowed to view the table at all.
Standard
View
Displays the Forwarding Database table as returned by the device.
Enhanced
View
Displays the Forwarding Database table on a per port basis. User can select a port
or group of ports to view its corresponding Forwarding Database entries.
Discard/Aging Time Info
Displays information about the number of address entries that were learned but
discarded because either there was a lack of memory or the entry's aging timer
expired.
Spanning Tree Info
STP Global Settings
Displays spanning tree parameters such as status and version.
MSTP Instance Info
Displays information about the Multiple Spanning Tree Protocol instance.
Note - The current firmware version does not allow the following parameters to be
configured: