Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 291)

AlliedView™-EMS 4.0.2 Device Management Guide Page 291 of 441
User Priority Regeneration
Displays the regenerated user priorities table.
Traffic Class
Displays the traffic class table.
Outbound Access Priority
Displays the outbound access priority table.
Bandwidth Control
Displays the bandwidth control table.
Note - Valid MIB Set values for the Receive Rate and Transmit Rate parameters are
in the range [1-10000] inclusive. However, specifying a value greater than 999 will
automatically set these parameters to 999.
Port Trunking
Basic Info
Displays basic information about port trunking.
Trunk Config
Displays port trunking parameteres and allows configuration of the master port,
member ports, trunk type and trunk status.
Note - The current firmware version does not allow the Member Ports and Trunk
Type parameters to be configured.
Aggregator Info
Displays information about every Aggregator that is associated with this system.
Note - The current firmware version returns 'noSuchName' for the Aggregate Index
parameter.
Note - The current firmware version does not allow the Actor System Priority and
Collector Maximum Delay parameters to be configured.
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Note - The current firmware version returns 'noSuchName' for the Port Number
parameter.
Note - The current firmware version does not allow the following parameters to be
configured: