Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 67)

AlliedView™-EMS 4.0.2 Device Management Guide Page 67 of 441
Physical Entity
Displays the information about the device including the serial number.
Note - The current firmware version accepts up to 6 characters for the Physical Alias
parameter.
Note - The current firmware version accepts up to 16 characters for the Physical
Asset ID parameter.
Note - The current firmware version is unable to display any value for the Serial
Number parameter.
Stacking Info
Basic Info
Displays the stacking information.
Note - Attempting to set the Stack Reload Unit parameter to a non-existing Unit ID
in the stack will cause the master device to restart.
Note - Valid MIB Set values for the Force Master Unit, Top Unit and Bottom Unit
parameters is [1-6] inclusive. However, the current firmware version allows the user
to set these parameters to '0'.
Note - The current firmware version does not allow the Stack Order Permutation
parameter to be configured.
Stack Info
Displays information about the stacked devices.
Stack Status
Displays the current unit ID and stack mode of the device after reset.
Note - Valid MIB Set values for the Active Unit ID After Reset parameter is [1-6]
inclusive. However, the current firmware version allows the user to set this
parameter to '0'.
Cascaded Ports Info
Displays cascaded ports information for stacked devices.
POE Info
Note - For devices configured in stacked mode, where at least one POE and one non-POE
devices are members of the stack, attempting to access the POE Config table will cause the
stacked devices to restart continuously unless the POE Config table is closed.
MCU Info
Displays POE device's Microcontroller information.