Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 168)

AlliedView™-EMS 4.0.2 Device Management Guide Page 168 of 441
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Standard
Displays port statistics such as the number of packets received and transmitted on
the port, bytes received and transmitted on the port and port status. This table also
displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the Promiscuous Mode and
Port Alias parameters to be configured.
Additional
Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port and port status.
Error
Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - Valid MIB Set values for the Port Flow Control parameter are 'disable' and
'enable'. Attempting to set Port Flow Control to 'unknown' will cause the parameter
to be set to 'enable'.
Note - Valid MIB Set values for the Port Back Pressure parameter are 'disable' and
'enable'. Attempting to set Port Back Pressure to 'unknown' will cause the
parameter to be set to 'enable'.
Note - The Port CoS/QoS Priority parameter is not applicable to the AT-8500 series
and should be ignored.
Note - AT-8550 : The current firmware version allows the Port Speed and Mode
parameter of a GBIC or SFP port to be set to '10Mbps full-duplex' or '100Mbps full-