Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 41)

AlliedView™-EMS 4.0.2 Device Management Guide Page 41 of 441
Syslog Device
Displays information about Syslog diagnostic messages.
Note - The current firmware version does not allow the Syslog Device Control
parameter to be configured.
Syslog Collector
Displays the information to generate Syslog messages to an aggregating agent or
collector.
Syslog Application
Displays information about a managed entity that provides individual control over
the severity level of the messages that it will generate.
Note - The current firmware version does not allow the Severity parameter to be
configured.
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Routing Menu
From the Routing menu, you can view and edit information about the switch's routing
functions.
IP
ARP Table
Displays the ARP cache on the switch.
Note - The current firmware version does not allow the Physical Address parameter
to be configured. Attempting to configure this parameter to any valid value will
result in the error "The error occurred with 'Set' operation. Error. bad value.".
Note - The current firmware version does not allow the Mapping Type parameter to
be configured. Attempting to configure this parameter from 'static' to 'dynamic' value
will result in the error "The error occurred with 'Set' operation. Error. bad value.".
Note - The current firmware version does not allow the Mapping Type parameter to
be set to 'invalid' or 'other' as its values.