Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 340)

AlliedView™-EMS 4.0.2 Device Management Guide Page 340 of 441
Note - Device Manager does not handle MIB table with Read-Create access
correctly. Attempting to set any parameters of this table will not be successful.
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Standard
Displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note - The following parameters are not applicable to the AT-x900-12X series and
should be ignored:
•
Specific Media MIB
•
Received Non Unicast Packets
•
Transmitted Non Unicast Packets
•
Transmitted Buffer Length
Note - Device Manager will not display the correct state of the ports and duplex
LEDs if logged-on in SNMPv3 mode using a user account with no read access to the
Interface Info parameters.
Additional Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port, and port status.
Note - The current firmware version returns a 'noSuchName' value for the following
parameters:
•
Received Bytes (HC)
•
Received Unicast Packets (HC)
•
Received Multicast Packets (HC)