Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 33)

AlliedView™-EMS 4.0.2 Device Management Guide Page 33 of 441
Device Manager LEDs for AT-8000GS Series
LED State Description
PWR Green The switch is receiving power.
STACK ID Orange
Gray
Green
The stacked unit is either the Stacking Master or the Backup
Master.
The switch is a set to standalone mode.
The stacked unit is a slave switch.
DUPLEX Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
Note - When multiple units of the AT-8000GS series are stacked together, port numbering
is continuous based on the Stack Number.
•
Stack 1 - 1 to 50
•
Stack 2 - 51 to 100
•
Stack 3 - 101 to 150
•
Stack 4 - 151 to 200
•
Stack 5 - 201 to 250
•
Stack 6 - 251 to 300
This numbering scheme assumes that a unit can have a maximum of 50 ports.
Note - The current firmware version does not allow the Device Manager to detect the
presence of an SFP module in any of the SFP slots unless there is an active connection on
the SFP ports. As a result, SFP images will appear on the device panel only if there is an
established connection on the physical SFP ports.
Note - The current firmware version does not allow the Device Manager to handle
redundant ports. As a result, the Duplex LED of the copper ports will remain green even if
there is an established connection on the equivalent SFP ports.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.