Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 40)

AlliedView™-EMS 4.0.2 Device Management Guide Page 40 of 441
Note - Valid MIB Set values for the DST Offset parameter should range from 1-1440.
However, the current firmware version allows the user to enter values outside of
the valid range and negative values as well.
Note - The current firmware version does not allow the DST Start and DST End
parameters to be configured when the DST Mode is set to 'recurring' or 'date' value.
SNTP/NTP Client Config
Displays information about SNTP/NTP client configuration.
Note - Valid MIB Set values for the Polling Interval parameter should range from 60-
86400. However, the current firmware version allows the user to enter values
outside of the valid range and negative values as well.
SNTP Config
Displays information about SNTP client configuration.
Broadcast Mode
Displays information about broadcast mode per interface.
Note - The current firmware version returns a 'noSuchName' value for the IP
Address parameter.
SNTP Server Info
Displays information about trusted SNTP servers to be queried in unicast or
broadcast mode.
Note - Valid MIB Set values for the Key Identifier parameter is [1-4294967295]
inclusive. However, the current firmware version allows the user to enter the value
'0'.
Authentication Keys
Displays information about keys information for authentication of NTP packets.
System Log
Basic Info
Displays information and configuration of the device's log files.
Note - The current firmware version does not allow the Clear Log File and Clear
Cache parameters to be configured.
Event Log
Displays information about events sent to the system log file.
Error Log
Displays information about errors registered to the system cache.