Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 406)

AlliedView™-EMS 4.0.2 Device Management Guide Page 406 of 441
Note - AT-CV5M01: The current firmware version does not allow Remote Ingress
Rate Limit and Remote Egress Rate Limit parameters to be configured. Attempting
to configure these parameters other than its current values will result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred."
Remote SFP Info
Displays the remote SFP of the AT-CM2K0s and AT-CM70S line cards.
Remote Port Statistics Info
Displays the remote port statistics information of the line cards.
Note - The current firmware version returns a 'noSuchName' value for the Remote
Data Transmitted parameter.
OAM Menu
From the OAM Menu, you can view information about OAM capabilities of the device.
OAM Config
Displays information about the device's administration status, max OAM PDU size
and configuration revision.
Note - Device Manager does not handle objects of type BITS correctly. As a result,
the Functions Supported parameter will display binary data instead of human-
readable data.
Note - AT-CV5M01: The current firmware version does not allow the Max OAM
PDU Size parameter to be configured.
OAM Statistics
Displays information about the device's transmitted and received frames, received
and transmitted loopback OAMPDU's and received and transmitted variable
responses.
OAM Peer Info
Displays information about the device's peer mac address, peer mode and peer
vendor info.
Note - The current firmware version does not return any value for the Peer
Functions Supported and Peer Vendor OUI parameters.
Loopback
Displays information on how to control loopback state and the status of the
loopback function.