Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 37)

AlliedView™-EMS 4.0.2 Device Management Guide Page 37 of 441
Note - Configuring the Row Status parameter to invalid values will not return an
error message except for the 'create and go' value.
Mid-level Management
Alarm Options
Displays information about alarm options.
Note - The current firmware version does not allow the Row Status parameter to be
configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error: gen Error.".
MIB Tree
Displays information about the device's MIB tree.
Tuning
Agent Diagnostics
Displays diagnostic information about the agent.
Note - The Location parameter is not applicable to the AT-8000GS series and should
be ignored.
General Tuning
Displays general tuning information.
Note - The current firmware version returns inconsistent values when configuring
the High Priority and Low Priority parameters.
Note - Valid MIB Set values for the Debug Level parameter should range from 1-100.
However, the current firmware version allows the user to enter values in the range
0-255.
Max Entries Tuning
Displays information about the maximum entries in tuning.
Note - The current firmware version does not allow the following parameters to be
configured:
•
Max IP Next Hop Entries After Reset
•
Max IP Prefixes After Reset
•
Max IP ECMP Entry Size After Reset
•
Max IP Interfaces After Reset
TCP Tuning
Displays the memory pool size for TCP tuning.
Syslog Tuning
Displays the current cache size and its size after reset.