Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 317)

AlliedView™-EMS 4.0.2 Device Management Guide Page 317 of 441
Discard/Aging Time Info
Displays information about the number of address entries that were learned but
discarded for reasons such as lack of memory or the entry's aging timer.
Note - Valid MIB Set values for the Aging Time parameter is in the range [10-630]
inclusive.
Spanning Tree Info
Displays spanning tree parameters such as priority and cost.
Statistics
Displays statistics about frames received/transmitted on the switch port.
Basic Bridge Info
Displays basic bridge information.
Bridge Port Info
Displays bridge port information.
Note - The current firmware version returns the value 'NULL' for the Circuit
parameter.
802.1p
Device Capabilities
Displays the device capabilities information.
Traffic Class
Displays the bridge traffic class and received traffic class info.
Note - The Traffic Class Priority parameter is not applicable to the AT-x600 series
and should be ignored.
Note - The Received Traffic Class parameter is implemented as 'read-only'.
LLDP Menu
From the LLDP menu, you can view and edit LLDP configurations, statistics, local system
data and remote systems data components.
Note - When multiple units of the AT-x600 series are stacked together, port numbering is
continuous based on the Stack ID.
•
Stack ID 1 = 1 - 50
•
Stack ID 2 = 51 - 100
•
Stack ID 3 = 101 - 150
•
Stack ID 4 = 151 - 200
•
Stack ID 5 = 201 - 250