Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 414)

AlliedView™-EMS 4.0.2 Device Management Guide Page 414 of 441
AT-CV102/2: 10/100TX to 100FX (SC, 40km, SM)
LED State Description
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
LCDS Green Line Card Dip Switch is enabled
Module Info
Note -The current firmware version does not return the correct value for the
Module MAC Address parameter.
Note - AT-CV5M01: Configuring the Module Operation Mode parameter will result
in the error message: "The error occurred with 'Set' operation. Error: time out
occurred".
Port Info
Note - The current firmware version does not allow any of the parameters under
this table to be configured.
AT-CV1KSS
1000X to 1000X SFP
LED State Description
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The current firmware version does not allow Device Manager to detect the presence
or absence of an SFP module in any of the SFP slots. As a result, the SFP slots on the device
image will always show SFP images regardless of whether or not SFP modules are physically
present in the slots.