Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 403)

AlliedView™-EMS 4.0.2 Device Management Guide Page 403 of 441
Note - Please refer to Converteon Series Modules for the operations and behavior of the
modules installed on the chassis.
Note - Using an SNMP v3 account that has a NO-READ VACM setting, a 'noSuchName' or
'noSuchObject' error may be displayed.
Note - While the Reset operation is in progress, error "The error with 'Set' operation.
Error: time out occurred." will be displayed and should be ignored.
Agent Menu
From the Agent Menu, you can view and edit the system information for the chassis, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note - The System Contact and System Name parameters accept inputs of up to 39
characters only while the System Location parameter accepts up to 38. Input values
that exceed these limits will be automatically truncated.
Network Info
Displays network-related information such as the addresses of the default gateway
and the TRAP Destination.
System Config
Displays common management information.
Note - The Temperature Threshold parameter is not applicable to the AT-CV1200
and should be ignored.
The following submenu options will only be available when AT-CV5M02
Management module is installed:
General Config
Displays the system's general configurations.
System Date and Time
Displays the configuration about the device's date, time and Network Time
Protocol.
Firmware Info
Displays information about the software release currently loaded in the device and
installed modules.