Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 419)

AlliedView™-EMS 4.0.2 Device Management Guide Page 419 of 441
•
Management Module 2.5V Status
•
Management Module 3.3V Status
•
Management Module 12.0V Status
•
Management Module Temperature
•
Management Module Software Version
•
Management Module Bootloader Version
•
Management Module Serial Number
•
Management Module Hardware Revision
Note - The current firmware version does not return valid values for the following
parameters when the Management Module Chassis ID is set to 31:
•
Module Location
•
Management Module Status
•
Management Module Present Status
•
Management Module Temperature Threshold
•
Reset Management Module
Module Info
Displays Module's information, including software and bootloader version of
linecards.
Note - The current firmware version will not return any information on the status of
the reset line card operation. As a result, Device Manager will not display any
indication that the reset line card operation was successful or not.
Note - The Module Location parameter always displays the value '???(N)'.
Power and Fan Module Slot Info
Displays Power and Fan Module's information including the module's serial number
and status.
Network Info
Displays network-related information such as the addresses of the default gateway
and the TRAP Destination.
System Config
Displays the device's system variables.
General Config
Displays the device's system configuration.
Note - Valid MIB Set values for the System Name, System Contact and System
Location parameters are in the range [0-25] inclusive. However, the current
firmware version accepts inputs of up to 40 characters.