Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 313)

AlliedView™-EMS 4.0.2 Device Management Guide Page 313 of 441
System Log
Log Entries
Displays information of the log entries on the device.
Note - The current firmware version returns a 'noSuchName' value intermittently
for the Log Entries parameter when using SNMPv1.
Log
Options
Displays the log options on the device.
Trigger
Trigger Info
Displays the trigger configuration information in the device.
Trigger
Counters
Displays counters in activation of the triggers in the device.
Remote Ping
Ping Objects
Displays the maximum number of concurrent active ping requests.
Note - The Target Address Type parameter is implemented as 'read-only'.
Ping
Control
Defines the Ping Control Table for providing, via SNMP, the capability of performing
ping operations at a remote host.
Note - Valid MIB Set values for the Data Size parameter should range from 0-65507.
However, the current firmware version does not allow this parameter to be set to
0-7 as its value.
Note - The current firmware version does not allow the Destination Port Number
parameter to be configured.
Note - Device Manager does not handle objects of type OCTET STRING correctly.
As a result, the Data Fill parameter will display a sequence of bytes in hexadecimal
format instead of the actual input value.
Note - The current firmware version does not allow Type parameter to be
configured.
Note - Device Manager does not handle objects of type BITS correctly. As a result,
the Trap Generation parameter will not be configurable and will display an 8-bit
binary string instead of the actual trap generation options allowed.
Ping
Results
Displays the results of the performed ping operations in the Ping Control table.