Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 357)

AlliedView™-EMS 4.0.2 Device Management Guide Page 357 of 441
Note - The current firmware version does not allow the Ingress Limit parameter to
be configured.
Error Statistics
Displays error statistics.
Note - The following parameters are not applicable to the AT-x900-24X series and
should be ignored:
•
Ethernet Chip Set
•
Symbol Errors
•
Duplex Status
•
Rate Control Ability
•
Rate Control Status
Spanning Tree Info
Displays the port's spanning tree parameters.
Note - The Path Cost Contribution parameter is not applicable to the AT-x900-24X
series and should be ignored.
Note - Valid MIB Set values for the Port Path Cost parameter is in the range [1-
65535] inclusive.
MAU Info
Displays interface-related MAU information for the port.
Note - The MAU Type List Bits and HC False Carriers parameters are not applicable
to the AT-x900-24X series and should be ignored.
Note - The MAU Status and Default MAU Type parameters are implemented as
'read-only'.
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note - The following parameters are not applicable to the AT-x900-24X series and
should be ignored:
•
Capability Bits
•
Advertised Bits
•
Received Bits
•
Remote Fault Advertised
•
Remote Fault Received
Note - The Administration Status, Advertised Negotiation Capability and Restart
parameters are implemented as 'read-only'.