Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 420)

AlliedView™-EMS 4.0.2 Device Management Guide Page 420 of 441
System Date and Time
Displays the system's Date, Time and Network Time Protocol configuration.
Note - Configuring the NTP Mode parameter to "Enable" will result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred." but
the NTP Mode will still be successfully set.
Note - Configuring the NTP Server parameter will result in the error message: "The
error occurred with 'Set' operation. Error: time out occurred." but the NTP Server
address will still be successfully set.
System Log
Displays the system's log information.
Reset
Resets the chassis and/or modules.
Telnet
Starts a Telnet connection to the chassis.
Status Menu
From the Status Menu, you can view information about AT-MCF2000 Modules installed on
the chassis.
Port Info
Displays the port cofigurable parameters. Options to view all/module 1/module 2
information are displayed including the configurable parameters for the management
port.
Management Port Info
Displays the Management Module's port information.
Note - Configuring the following parameters to any valid value will result in the error
message: "The error occurred with 'Set' operation. Error: time out occurred." but
values will still be successfully set.
ƒ Management Port Auto Negotiation
ƒ Management Port Speed
ƒ Management Port MDIX
Note - The current firmware version does not allow the Port Ingress Rate Limit and
Port Egress Rate Limit parameters to be configured. Attempting to set these
parameters to valid values will result in the error message: " The error occurred
with 'Set' operation. Error: bad value.".