Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 154)

AlliedView™-EMS 4.0.2 Device Management Guide Page 154 of 441
Note - The DLCMI Status and Row Status parameters are not applicable to the AT-
AR700S series and should be ignored.
Note - The following parameters are implemented as 'read-only':
ƒ DLCMI State
ƒ Address Type
ƒ Address Length
ƒ Polling Interval of Successive Status
ƒ Polling Interval of Full Status Enquiry
ƒ Error Threshold
ƒ Monitored Error Events
ƒ Max Supported VC Numbers
ƒ Multicast Type
Virtual Circuits
Displays Frame Relay circuit statistics.
Note - The following parameters are not applicable to the AT-AR700S series and
should be ignored:
ƒ Multicast Type
ƒ Type
ƒ Discards
ƒ Received DEs
ƒ Sent DEs
ƒ Logical Interface Index
ƒ Row Status
Note - The following parameters are implemented as 'read-only':
ƒ State
ƒ CIR
ƒ Maximum Line Speed
ƒ Throughput
Errors
Displays information about errors related to the Frame Relay module.
Note - The Faults and Fault Time parameters are not applicable to the AT-AR700S
series and should be ignored.
DS1
DS1 Config
Displays DS1 configuration.
Note - The current firmware version returns a 'noSuchName' value for the Port
Number parameter.