Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 71)

AlliedView™-EMS 4.0.2 Device Management Guide Page 71 of 441
LCLI Info
Displays information about the device's Telnet sessions and SSH sessions if
enabled or not.
Note - Valid MIB Set values for History Size, Telnet History Size and SSH
History Size parameters should range from 10 to 210. However, the current
firmware version allows the user to enter values up to 246.
RS-232
Displays the configuration of the baud rate of the device.
Web Server
Displays the configuration about the HTTP and HTTPS Port the device used.
Web Info
Displays embedded Web protocol.
Note - Setting the HTTP Port and HTTPS Port parameters to '0' will
automatically set the parameters to their default port numbers which are 80
and 443 respectively.
Web Services
Displays the services used for the embedded Web protocol.
Note - The current firmware version does not allow Service Protocol
parameter to be configured.
Note - Valid MIB Set values for Service Certificate ID parameter should range
from 0 to 1000. However, the current firmware version allows user to enter
values in the range [-2147483648 to 2147483647] inclusive. Attempting to
enter values greater than 2147483647 will cause the new value to be
converted to its equivalent wrap-around value; i.e., 2147483648 will become
-2147483648, 2147483649 will become -2147483647, and so on.
Date and Time
Time Synchronization
Displays the configuration about the device's date/time and time zone.
Note - The current firmware version does not allow DST End and DST Start
parameters to be configured.
Note - Valid MIB Set values for the DST Offset parameter should range from 1 to
1440. However, the current firmware version allows the user to enter values in the
range [-2147483648 to 2147483647] inclusive. Attempting to enter values greater
than 2147483647 will cause the new value to be converted to its equivalent wrap-
around value; i.e., 2147483648 will become -2147483648, 2147483649 will become -
2147483647, and so on.