Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 318)

AlliedView™-EMS 4.0.2 Device Management Guide Page 318 of 441
•
Stack ID 6 = 251 - 300
•
Stack ID 7 = 301 - 350
This numbering scheme assumes that a unit can have a maximum of 50 ports.
LLDP Configuration
General Config
Displays LLDP general function such as enabling LLDP, transmission delays and
others.
Port
Config
Standard
Displays the LLDP configuration information of a particular port.
Note - Device Manager does not handle objects of type BITS correctly. As a
result, the TLVs Tx Enable parameter will not be configurable and will display
an 8-bit binary string instead of the actual TLV types allowed. However, the
TLV types allowed can still be determined by looking at the bits that are on
from left to right:
•
Bit 0 - Port Description
•
Bit 1 - System Name
•
Bit 2 - System Description
•
Bit 3 - System Capabilities
Additional Info
Displays the control selection of LLDP Port VLAN-ID TLVs (Type-Length-
Value) to be transmitted on individual ports.
Management Addresses
Displays control selection of LLDP management address TLV instances to be
transmitted.
Note - Device Manager does not handle objects of type OCTET STRING correctly.
As a result, the Ports Tx Enable parameter will display a sequence of bytes in
hexadecimal format instead of the actual input value.
Optional TLVs
VLAN Names
Displays the set of ports on which the Local System VLAN name instance will be
transmitted.
Protocol
VLANs
Displays the set of ports on which the Local System Protocol VLAN instance will be
transmitted.
Protocol IDs
Displays the set of ports on which the Local System Protocol instance will be
transmitted.