Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 43)

AlliedView™-EMS 4.0.2 Device Management Guide Page 43 of 441
Note - Configuring the Get Config File parameter will cause the device to reboot and
reset its running configuration to default configuration.
Note - The current firmware version does not allow the File Server IP Address
parameter to be configured.
UDP
Listener Info
Displays UDP listener information.
UDP
Statistics
Displays UDP statistics.
TCP
Connection Info
Displays TCP connection-specific information.
Note - The current firmware version does not allow the Connection Status
parameter to be configured. Attempting to configure this parameter to any valid
value will result in the error "The error occurred with 'Set' operation. Error: gen
Error.".
TCP Statistics
Displays TCP statistics.
CIDR
Route Number
Displays the number of valid CIDR entries.
Route Table
Displays the CIDR routing tables.
Note - The current firmware version does not allow the Routing Type parameter to
be configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error. bad value.".
Note - The current firmware version does not allow the following parameters to be
configured:
o
Destination Port Number
o
Routing Protocol MIB
o
Destination Metric 2
o
Destination Metric 3
o
Destination Metric 4
o
Destination Metric 5
Note - The current firmware version only allows the Routing Type parameter to be
set to 'reject' if the value prior to set operation is 'remote'.