Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 58)

AlliedView™-EMS 4.0.2 Device Management Guide Page 58 of 441
Additional Info
Displays additional information about the port's interface info.
Note - The current firmware version returns a 'noSuchName' value for the following
parameters:
o
Transmitted Buffer Length
o
Received Unicast Packets (HC)
o
Received Multicast Packets (HC)
o
Received Broadcast Packets (HC)
o
Transmitted Unicast Packets (HC)
o
Transmitted Multicast Packets (HC)
o
Transmitted Broadcast Packets (HC)
Note - The current firmware version does not allow the Promiscuous Mode
parameter to be set to 'false' as its value.
Note - The current firmware version returns the value 'NULL' for the Specific Media
MIB parameter.
PHY Diagnostics
Test Interface
Displays entries containing objects for invoking tests on an interface.
Note - The current firmware version does not allow the Test Set Type parameter to
be configured. Attempting to configure this parameter to any valid value will result in
the error "The error occurred with 'Set' operation. Error. bad value.".
TDR Diagnostics Table
Displays entries containing results of tests on an interface.
Error Statistics
Displays error statistics for the ports.
Note - The current firmware version returns a 'noSuchName' value for the following
parameters:
o
Alignment Error Frames
o
Multi Collision Frames
o
SQE Test Errors
o
Deferred Transmissions
o
Carrier Sense Errors
o
Symbol Errors
Note - The Ethernet Chip Set parameter is not applicable to the AT-8000GS series
and should be ignored.