Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 39)

AlliedView™-EMS 4.0.2 Device Management Guide Page 39 of 441
Telnet Sessions
Displays the login time, client IP address and telnet session status.
CLI Info
Displays information if the file is enabled or not.
Note - The current firmware does not allow the Password parameter to be
configured.
LCLI Info
Displays information about the device's Telnet sessions and SSH sessions if enabled
or not.
Note - Valid MIB Set values for the History Size and SSH History Size parameters
should range from 10-206 and 10-210 respectively. However, the current firmware
version allows the user to enter values up to 246.
Note - Valid MIB Set values for the Telnet History Size parameter is [10-206]
inclusive. However, the current firmware version allows the user to enter values up
to 246.
RS-232
Displays the configuration of the baud rate of the device.
Web Server
Web Info
Displays embedded Web protocol.
Note - Setting the HTTP Port and HTTPS Port parameters to ?0? will automatically
set the parameters to their default port numbers which are 80 and 443 respectively.
Web Services
Displays the services used for the embedded Web protocol.
Note - The current firmware version does not allow the Service Port, Service
Certificate and Service Max Idle Timeout parameters to be set to '0', '1000' and
'932160' values respectively.
Note - Valid MIB Set values for the Service Certificate ID parameter is [0-1000]
inclusive. However, the current firmware version allows the user to enter '-1' and
'1001' as its value.
Note - The current firmware version does not allow the Service Protocol parameter
to be configured.
Date and Time
Time Synchronization
Displays the configuration about the device's date/time and time zone.