beautypg.com

Allied Telesis AlliedView-EMS 4.0.2 Device-Manager User Manual

Page 42

background image


AlliedView™-EMS 4.0.2 Device Management Guide

Page 42 of 441

Address

Table

Standard

Displays the list of IP interfaces on the switch.

Additional Info

Displays additional information about the address table.

Note

- The Backup Address parameter is not applicable to the AT-8000GS

series and should be ignored.

Note

- The current firmware version does not allow the IP Interface Owner

parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.

Error. bad value.".

Note

- Configuring the Port Number parameter will cause the device to be

inaccessible and may need the restarted.

Note

- The current firmware version does not allow the Net Mask parameter

to be configured.


Static Route Table

Displays the IP static routing table.

Note

- The current firmware version does not allow the Routing Type parameter to

be set to 'local' as its value.


IP Statistics

Displays statistics about IP routing, including the number of IP datagram received.

Note

- The current firmware version does not allow the Forwarding Status

parameter to be configured. Attempting to configure this parameter to any valid

value will result in the error "The error occurred with 'Set' operation. Error. bad

value.".


ARP Table Config

Displays configuration information about ARP.


I/F Name-Address Translation

Displays information about the IP interface's name translated to an IP interface

address.


TFTP

Displays configuration information about the TFTP.

Note

- The current firmware version does not allow the Send Config File parameter

to be configured.