Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 101)

AlliedView™-EMS 4.0.2 Device Management Guide Page 101 of 441
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.
Note - The current firmware version does not allow the DNS Server and Default
Domain Name parameters to be configured. Attempting to configure these
parameters will result in the error message: "The error occurred with 'Set'
operation. Error: gen Error.".
Chassis Info
Displays chassis information including the firmware information.
Note -The current firmware version does not allow the Power A Status and Power B
Status parameters to be configured. Attempting to configure these parameters will
result in the error message: "The error occurred with 'Set' operation. Error: gen
Error.".
Line Card Info
Displays information for each line card including line card type and line card
temperature.
MAC Address Table
Displays a list of static MAC address configured on the switch.
Note - Valid MIB Set values for the MAC Address Entry Status parameter are 'active',
'not in service' and 'destroy'. Attempting to set this parameter to any other value
will result in error message: "The error occurred with 'Set' operation. Error: bad
value".
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database and the spanning tree status.
Forwarding Database
Displays the Forwarding Database table.