Allied Telesis AlliedView-EMS 4.0.2 Device-Manager - Manual (Page 260)

AlliedView™-EMS 4.0.2 Device Management Guide Page 260 of 441
Error Statistics
Standard
Displays port error statistics such as error frames and collision frames. It also
displays deferred transmissions and ethernet chipset information.
Note - When multiple units of the AT-9400 are stacked together, and the master
switch is an AT-9424Ts or an AT-9424Ts/XP, the current firmware version returns
incorrect values for the Error Statistics parameter.
Note - L3 Models: The current firmware version returns the value 'NULL' for the
Ethernet Chip Set parameter.
Additional
Info
Displays Bad Frames Received and Collision parameters.
Note - Use SNMP v2c or v3 to view this table.
Detail Info
Displays detailed port information such as duplex mode.
Note - The Port MDIO parameter is not applicable to the AT-9408LC/SP.
Note - The Port CoS/QoS Priority and Port STP State parameters are not applicable
to the AT-9400 series and should be ignored.
Note - Valid MIB Set values for the Port Flow Control and Port Back Pressure
parameters are 'disable' and 'enable'. Attempting to set these parameters to
'unknown' will cause them to be set to 'enable'.
Note - Configuring the Port HOL Limit parameter of a slave switch to any value
within the range [1-8191] will return a Set Error and will cause the master device to
restart.
Note - L3 Models: The current firmware version does not allow the Port Speed and
Port Duplex parameters to be configured to the desired port speed and duplex
mode. As a result, the speed label that will be displayed on the port image and its
corresponding DUP LED will depend on the actual speed and duplex mode detected
by the device.
Note - AT-94xxTs/XP: The current firmware version returns the value 'unknown' for
the Port Speed parameter of the XFP ports.
Note - L3 Models: The current firmware version does not return any Set Error when
setting the Port Speed and Mode parameter of SFP/RJ-45 combo ports to 1Gbps
half-duplex.