Allied Telesis AT-9000 Series - Manual (Page 63)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
63
Figure 22. Port Configuration Modify Page
5. Configure the following parameters as needed:
 Interface— Port number. You cannot modify this field.
 Port Type— Type of port, fiber or copper. You cannot modify this
field.
 Status— Specifies if the port is enabled or disabled. Choose
between “Enabled” or “Disabled.” The default setting is “Enabled.”
Disabling ports turns off their receivers and transmitters so that
they cannot forward traffic. You may want to disable a port if there
is a problem with a cable or network device.