Allied Telesis AT-9000 Series - Manual (Page 240)

Chapter 19: Setting LLDP and LLDP-MED
240
The following fields are displayed:
 ID— LLDP Coordinate Location ID.
 Latitude— Latitude value in decimal degrees.
 Latitude Resolution— Latitude resolution as the number of valid
bits.
 Longitude— Longitude value in decimal degrees.
 Longitude Resolution— Longitude resolution as the number of
valid bits.
 Altitude— Altitude in meters or floors.
 Altitude Resolution— Altitude resolution as the number of valid
bits.
 Datum— Geodetic system (or datum) of the coordinates:
nad83-mllw Mean lower low water datum 1983
nad83-navd North American vertical datum 1983
wgs84 World Geodetic System 1984
Displaying ELIN
Locations
To display an LLDP ELIN location, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab appears on the right.
3. From the LLDP tab, hover over Locations.
The Locations tab is displayed. See Figure 74 on page 212.
4. From the Locations tab, move the cursor to the right and select ELIN.
The LLDP ELIN Location page is displayed. See Figure 79 on page
217.
The following fields are displayed:
 ID— ID number for an LLDP-MED coordinate location entry on the
switch.
 ELIN LOCATION— ELIN of 10 to 25 digits.