Allied Telesis AT-9000 Series - Manual (Page 232)

Chapter 19: Setting LLDP and LLDP-MED
232
 System Capabilities— Capabilities that are supported and
enabled on the neighbor. The System Capabilities codes are:
O = Other
P = Repeater
B = Bridge
W = Wireless Access Point
R = Router
T = Telephone
C= Cable Device
S = Station only
 Med Device class and Power Source code— The MED device
Classes I through III are supported. Power Source code indicates
the current power source which is either the Primary Power Source
or the Backup Power Source. The codes are:
C1 = Class I
C2 = Class II
C3 = Class III
N = Network
L = Local
PSE = PoE
prim = Primary
UN = Unknown
Ba = Backup
Displaying LLDP
Neighbor Detail
To display LLDP Neighbor detailed information, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab, hover over LLDP, move the
cursor to the right, and then select Neighbors.
The LLDP Neighbors Information page is displayed. See Figure 91 on
page 231.