Allied Telesis AT-9000 Series - Manual (Page 37)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
37
Setting a Telnet or SSH Server
The AlliedWare Plus Web Browser interface allows you to configure the
switch as a Telnet or SSH server.
You can use the web browser interface to enable a Telnet server, but not
as a Telnet client. The Telnet client is only supported from the CLI. For
information about how to use a Telnet client, see the AlliedWare Plus
Management Software Command Line Interface User’s Guide.
To enable an SSH server in the web interface, you must first create an
encryption key in the CLI interface. Then, you can enable the SSH server
in the web interface.
The procedures in this section allow you to configure the switch as a
Telnet or SSH server.
To enable Telnet or SSH server on the switch, do the following:
1. From the home page, hover the cursor over the System tab.
2. From the System tab, hover over System Settings.
The System Settings tab is displayed. See Figure 6 on page 33.
3. Move the cursor to the right and select Services from the drop-down
menu.
The System Services page is displayed. See Figure 10.
Figure 10. System Services Page