Allied Telesis AT-9000 Series - Manual (Page 25)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
25
 IPv6 Gateway— IPv6 address of the next hop of the switch’s
default route. The switch uses a default route when it must
communicate with a device that is not on the local IPv6 network.
The Services section displays the following information:
 SNMP— SNMP setting of the switch.
 HTTP— HTTP setting of the switch
 Telnet— Indicates if Telnet is enabled or disabled on the switch.
 SSH— Indicates if SSH is enabled or disabled on the switch.
 Spanning Tree— Indicates if STP, RSTP, or MSTP is enabled on
the switch. The default setting is “RSTP.”
 QoS— Indicates if QoS is enabled or disabled on the switch.
 LLDP— Indicates if LLDP is enabled or disabled on the switch.
 SFLOW— Indicates if sFlow is enabled or disabled on the switch.
 802.1x Port Authentication— Indicates if 802.1x Port
Authentication is enabled or disabled on the switch.
 Remote Logging— Indicates if the remote log is enabled or
disabled on the switch.
 IGMP Snooping— Indicates if IGMP Snooping is enabled or
disabled on the switch.
The Administration Options section displays the following information:
 System Upgrade— Select this field to upgrade your system
software. See “Upgrading the Software” on page 50.
 Reboot— Select this field to reboot the switch. For instructions,
see “Rebooting a Switch” on page 49.