Starting a web management session, Figure 1: login menu – Allied Telesis AT-9000 Series User Manual
Page 20
Chapter 2: Starting a Management Session
20
Starting a Web Management Session
Before you start a remote web management session, you must log onto
the AlliedWare Plus CLI and assign an IP address to the switch. Also, you
must enable web management on the switch, which is disabled by default.
To assign an IP address, enable web management, and start a web
management session on an AT-9000 switch, do the following:
Note
If you have already assigned the switch an IP address and enabled
the web management, start with Step 8.
1. Log on to the AlliedWare Plus CLI.
The Login Menu is shown in Figure 1.
Figure 1. Login Menu
2. Enter “manager” for the login name and press Return.
You are prompted for a password.
3. Enter “friend” as the password and press Return.
The “awplus>” prompt indicates that you are logged on to the switch.
4. Assign an IP address and subnet mask to the switch by entering the
following commands:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ip address 167.142.10.5/16
Press
awplus login: