Allied Telesis AT-9000 Series - Manual (Page 254)

Chapter 20: Setting sFlow
254
Specifying an sFlow Collector
Use this procedure to specify the IP addresses and the UDP ports of the
sFlow collectors on your network. The packet sampling data and the
packet counters are sent by the switch to the collectors specified. You can
specify up to four collectors, but you can add only one address at a time
with this procedure.
To select the Collectors tab from the sFlow page, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab drop-down menu, select
sFlow.
The sFlow page is displayed with the Port Configurations tab selected.
See Figure 98 on page 256.
3. From the sFlow page, select the Collectors tab.
The sFlow page is displayed with the Collectors Tab selected. See
Figure 96.
Figure 96. sFlow Page with Collectors Tab
4. Click Add.
The sFlow Collector page is displayed. See Figure 97 on page 255.