Allied Telesis AT-9000 Series - Manual (Page 219)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
219
Configuring LLDP and LLDP-MED
To configure LLDP and LLDP-MED, perform the following procedures:
 “Setting the Basic LLDP Configuration”
 “Setting LLDP Port Assignments” on page 220
 “Assigning Port Locations” on page 222
 “Enabling LLDP TLV” on page 224
 “Enabling LLDP- MED TLV” on page 228
Setting the Basic
LLDP
Configuration
To set the basic LLDP configuration, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab appears to the right.
3. From the LLDP tab, move the cursor to the right and select Basic
Configuration.
The LLDP Configuration page is displayed. See Figure 81.
Figure 81. LLDP Configuration Page