Allied Telesis AT-9000 Series - Manual (Page 54)

Chapter 3: Basic Switch Parameters
54
 System Contact— Contact person for the switch. To configure
this field, see “Setting the Switch Information” on page 40.
 System Location— Location of the switch. To configure this field,
see “Setting the Switch Information” on page 40.
 Management VLAN— Management VLAN assigned to the switch.
The default VLAN is “VLAN1.”
 IPv6 Gateway— IPv6 address of the next hop of the switch’s
default route. The switch uses a default route to reach a remote
subnet.
 IPv6 Address— IPv6 address and subnet mask of the web
interface. An IPv6 management address for the switch is entered
in the following format:
nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn
Where “n” is a hexadecimal digit from 0 to F. The eight groups of
digits are separated by colons. Groups where all four digits are “0”
can be omitted. Leading “0”s in groups can also be omitted. For
example, the following IPv6 addresses are equivalent:
12c4:421e:09a8:0000:0000:0000:00a4:1c50
12c4:421e:9a8::a4:1c50
The Services section displays the following information:
 SNMP— SNMP setting of the switch.
 HTTP— HTTP setting of the switch
 Telnet— Indicates if Telnet is enabled or disabled on the switch.
 SSH— Indicates if SSH is enabled or disabled on the switch.
 Spanning Tree— Indicates if STP, RSTP, or MSTP is enabled on
the switch. The default setting is “RSTP.”
 QoS— Indicates if QoS is enabled or disabled on the switch.
 LLDP— Indicates if LLDP is enabled or disabled on the switch.
 SFLOW— Indicates if sFlow is enabled or disabled on the switch.
 802.1x Port Authentication— Indicates if 802.1x Port
Authentication is enabled or disabled on the switch.
 Remote Logging— Indicates if the remote log is enabled or
disabled on the switch.
 IGMP Snooping— Indicates if IGMP Snooping is enabled or
disabled on the switch.