Allied Telesis AT-9000 Series - Manual (Page 120)

Chapter 10: Setting Static Port Trunks
120
Modifying the Static Trunk Settings
Review the following information if you are adding ports to an existing
trunk:
 If the port you are adding is the lowest numbered port in the trunk, its
parameter settings overwrites the settings of the existing ports in the
trunk. Therefore, check if its settings are appropriate before adding it
to the trunk. If the new port is not the lowest numbered port, its port
settings are changed to match the settings of the existing ports in the
trunk.
 If the new port added to a trunk is already a member of another static
trunk, you must first remove it from its current trunk assignment.
To add or delete member ports from a static port trunk, do the following:
1. Hover the cursor over the Switching tab.
The Switching tab is displayed. See Figure 20 on page 59.
2. From the Switching tab, hover over Link Aggregation.
For an example of the Link Aggregation selection, see Figure 42 on
page 115.
3. Move the cursor to the right and select Static Trunks.
The Static Trunks page is displayed. See Figure 44 on page 116.
4. From the Static Trunks page, click Edit.
The Modify Static Trunk page is displayed. See Figure 46 on page
121.