Allied Telesis AT-9000 Series - Manual (Page 241)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
241
Displaying LLDP and LLDP-MED Settings
To display the LLDP and LLDP-MED settings, use the following
procedures:
 “Displaying the Basic LLDP Configuration”
 “Displaying LLDP Port Assignments” on page 242
 “Displaying Port Locations” on page 243
 “Displaying LLDP TLV” on page 243
 “Displaying LLDP-MED TLV” on page 245
For information about configuring LLDP and LLDP-MED, see “Configuring
LLDP and LLDP-MED” on page 219
Displaying the
Basic LLDP
Configuration
To display the basic LLDP configuration, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab appears to the right.
3. From the LLDP tab, select Basic Configuration.
The LLDP Configuration page is displayed. See Figure 81 on page
219.
The following fields are displayed:
 Status— Whether LLDP is enabled or disabled on the switch.
 Timer— Transmit interval.
 Fast Start Count— Fast-start count for LLDP-MED. The fast-start
count determines how many fast start advertisements LLDP sends
from a port when it begins sending LLDP-MED advertisements
from a port, for instance when it detects a new LLDP-MED capable
device.
 Holdtime Multiplier— Holdtime multiplier value. The transmit
interval is multiplied by the holdtime multiplier to give the Time To
Live (TTL) the switch advertises to the neighbors.
 Non Strict Med TLV Order Check— Indicates whether the switch
accepts LLDP-MED advertisements when the TLVs are not in the
standard order, as specified in ANSI/TIA-1057.
 Notification Interval— Notification interval. This is the minimum