Figure 2: displaying the ip address – Allied Telesis AT-9000 Series User Manual
Page 21
AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
21
5. Display the IP address assigned to VLAN 1 by entering the following
commands:
awplus(config-if)# exit
awplus(config)# exit
awplus# show ip interface
For a display of this command, see Figure 2.
Figure 2. Displaying the IP address
6. Enable the web browser on the switch by entering the following
commands:
awplus# configure terminal
awplus(config)# http server
If using HTTPS, enter the following commands:
awplus# configure terminal
awplus(config)# service https
7. Save your changes on the switch by copying the running configuration
file to the start-up configuration file. Enter the following command:
awplus# copy running-config startup-config
8. Open a web browser, such as Microsoft Explorer, and enter one of the
following:
To start an HTTP session, enter: http:// followed by the IP address
of the switch.
To start an HTTPS session, enter: https:// followed by the IP
address of the switch.
The Login Page is displayed. See Figure 3 on page 22.
awplus# show ip interface
Interface
IP-Address
Status
Protocol
vlan1-0
167.142.10.5/16 admin up
running