Allied Telesis AT-9000 Series - Manual (Page 42)

Chapter 3: Basic Switch Parameters
42
Setting the Configuration File
Within the web browser interface, you can upload a configuration file on to
the switch, download a configuration file from the switch, or delete a
configuration file. In addition, you can save your changes to the
current configuration file. However, to create a new configuration file, you
must access the switch through the CLI.
The file that you select in this procedure is the file that the switch uses the
next time you reboot the switch.
See the following procedures:
 “Displaying and Setting the Active Configuration File”
 “Uploading a Configuration File” on page 43
Displaying and
Setting the Active
Configuration
File
The file you select in this procedure is the active configuration file after you
reboot the switch.
To select the active configuration file, do the following:
1. From the home page, hover the cursor over the System tab.
2. From the System tab, hover over System Settings.
The System Settings tab is displayed. See Figure 6 on page 33.
3. From the System tab, select Configuration Files from the pull-down
menu.
For an example of the Configuration Files page, see Figure 12.
Figure 12. Configuration Files Page