Allied Telesis AT-9000 Series - Manual (Page 244)

Chapter 19: Setting LLDP and LLDP-MED
244
4. From the LLDP TLV tab, select TLV again.
The LLDP TLV page is displayed. See Figure 87 on page 225.
The following fields are displayed:
 Interface— Port number.
 Port Description— Port description of the neighbor’s port.
 System Name— Neighbor’s system name.
 System Description— Model number of the AT-9000 switch.
 System Capabilities— Device’s router and bridge functions, and
whether or not these functions are currently enabled.
 Management Address— IP address of the local LLDP agent. This
is used to obtain information related to the local device.
 Port Vlan— VID of the VLAN in which the transmitting port is an
untagged member.
 Port and Protocol Vlans— Whether the device supports protocol
VLANs and, if it does, the protocol VLAN identifiers. This field is
not supported on the AT-9000 switches.
 Vlan Names— Names of the VLANs in which the transmitting port
is either an untagged or tagged member.
 Protocol Ids— Protocols that are accessible through the port, for
instance:
- 9000 (Loopback)
- 0026424203000000 (STP, RSTP, or MSTP)
- 888e01 (802.1x)
- AAAA03 (EPSR)
- 88090101 (LACP)
- 00540000e302 (Loop protection)
- 0800 (IPv4)
- 0806 (ARP)
- 86dd (IPv6)
 MAC Phy Config— Speed and duplex mode of the port and
whether the port was configured with Auto-Negotiation.
 Link Aggregation— Whether the port is capable of link
aggregation, and if so, whether it is currently a member of an
aggregator.
 Max Frame Size— Sends the maximum supported frame size of
the port. This field is not adjustable on the switch.