Allied Telesis AT-9000 Series - Manual (Page 224)

Chapter 19: Setting LLDP and LLDP-MED
224
Figure 85. Modify LLDP Port Location Page
5. Change the parameters as needed. Use the drop-down menu next to a
field to select.
 Interface— Indicates the port number. You cannot modify this
parameter on this page.
 Civic Location ID— Use the pull-down menu to add civic location
information to the port. The specified location entry must already
exist.
 Coordinate Location ID— Use the pull-down menu to add LLDP-
MED coordinate information to the port. The specified location
entry must already exist.
 ELIN Location ID— Use the pull-down menu to add ELIN location
information to the port. The specified location entry must already
exist.
6. Click Apply.
7. Click SAVE.
Enabling LLDP
TLV
To enable LLDP TLV, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 73 on page
211.
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab is displayed.