Allied Telesis AT-9000 Series - Manual (Page 39)

AlliedWare Plus Version 2.1.8 Management Software Web Interface User’s Guide
39
Setting a Remote Log Server
You can use the AlliedWare Plus Web browser interface to enable logging
to a remote log server, which is part of the Syslog feature. However, you
must use the CLI to view or clear the event log. For information about the
CLI, see the Syslog chapters in the AlliedWare Plus Management
Software Command Line Interface User’s Guide.
To activate remote logging on the switch, do the following:
1. Hover the cursor over the System tab.
2. From the System tab, hover over System Settings.
The System Settings tab is displayed. See Figure 6 on page 33.
3. Move the cursor to the right and select Services.
The System Services page is displayed. See Figure 10 on page 37.
4. Configure the following parameters as necessary:
 Remote Log— Enables the switch to send status and error
messages to a remote log server. This parameter is optional.
 Server IP Address— Specifies the IP address of the remote log
server. This field is mandatory if you selected the Remote Log field
above. You can enter the IP address in the IPv4 format:
xxx.xxx.xxx.xxx.
where each xxx is a decimal number from 0 to 255. The numbers
are separated by periods.
5. Click Apply.
6. Click SAVE to save your changes on the switch.