Allied Telesis AT-9000 Series - Manual (Page 182)

Chapter 16: Setting RADIUS and TACACS+ Clients
182
 AAA Authentication Enable Local— Enable or disable
TACACS+ to authenticate users requesting the Privileged Exec
mode. Choose from the following:
Enabled: The TACACS+ determines whether users can
access the Privileged EXEC level using the TACACS+ enable
password. When any TACACS+ server is not available,
authentication is attempted using the password specified using
the ENABLE PASSWORD command in the CLI.
Disabled: The TACACS+ servers do not use its enable
password. Authentication is attempted using the password
specified using the ENABLE PASSWORD command in the
CLI.
 AAA Accounting— Select a TACACS+ accounting setting.
Choose from the following:
Start-Stop: A start accounting message is sent at the
beginning of a session, and a stop accounting message is sent
at the end of the session.
Stop-Only: A stop accounting message is sent at the end of
the session.
None: Sending accounting messages is disabled.
5. Click Apply.
The Active Authentication Server field shown on the upper middle of
the page indicates “TACACS+.”
6. Click SAVE.
Adding a
TACACS+
Server
To add a TACACS+ server, do the following:
1. Click Add at the bottom of the page.
The TACACS+ Add page is displayed. See Figure 63 on page 183.