HP StoreEver ESL G3 Tape Libraries - Manual (Page 47)

•
If the DNS Server has been configured through the LMC (Setup
→DNS Configuration),
type the valid alpha/numeric IP Addresses that are accessible from the library. You have
the option of using one or two IP addresses.
•
If NTP is enabled and you no longer want to use this setting, click Disable.
5. Use the Date drop-down lists to select the month, date, and year.
6. Use the Time drop-down lists to select the hour, minute, and whether the time is A.M. or P.M.
7. Use the Time Zone drop-down list to select the appropriate time zone.
NOTE: The default time zone is GMT. The time zone that you select appears only on your
library information panel. Regardless of your selection, the system operates on the GMT zone.
8. Click OK.
Filling the library with cartridges (bulk loading)
Before your library is operational, place cartridges into the slots of the magazines lining the interior
of your library.
•
Make certain the barcode side is facing out of the slot.
•
Make certain that the cartridge is completely seated in the slot. Accessor motion can be
impeded if the cartridge is not completely seated within the slot.
•
You should not be able to see the name of the media type typically printed on the top of the
cartridge by the manufacturer.
When your library is operational, use the I/E Station to add additional cartridges. Insert the
cartridges in the slots of the I/E Station. Then use Operations
→Import to import the cartridges.
Setting up the network configuration
Make sure that your library is attached to the network before you use the Network
Configuration
command.
CAUTION: You must fully understand all network issues before you change the network
configuration for an already configured library. It is recommended that you consult with your
network administrator before changing your network configuration.
NOTE: To set up an IPv6 network connection, make sure that the IPv6 option is enabled on the
Physical Library dialog box.
To set up the network configuration:
1. Log on as an administrator.
2. If you are not already working from the physical library, select the physical library from the
View menu.
3. From the menu bar, click Setup
→Network Configuration→Network Configuration.
4. Depending on whether IPv6 is enabled or disabled and the protocol of the network connection
you want to configure:
IMPORTANT: Please note that with the MCB Version 2 with dual Ethernet ports, the two
ports must be configured to be on different subnets or else the library will not function correctly.
Filling the library with cartridges (bulk loading) 47